Description
- 1x 1.3 Inches 128×64 OLED Display with SSD1306 controller.
- 1x Connector for Wi-Fi Module DT-06 or Bluetooth Module HC-06.
- 1x Micro-SD slot for Data Logging or Memory Extension.
- 1x Real Time Clock with CR1220 3V back-up battery slot. (Coin cell battery not included)
- 1x Temperature sensor.
- 17x GPIOs with YELLOW Low Power LEDs (3 GPIOS are buffered).
- 2x GREEN status Low Power LEDs on +5V and +3.3V.
- 5x Analog inputs with buffered YELLOW Low Power LEDs.
- 2x WHITE LEDs for Dark Environment.
- 1x RED Low Power LED for the Reset Pin.
- 1x RED Low Power LED for Serial RX and GREEN for Serial TX.
- 1x Push-Button wired to an INTERRUPTION Input.
- 1x Piezo Buzzer
- 1x ON/OFF Power Switch.
- 1x Slot for a 2 wire Voltmeter (included).
- 1x Micro USB Connector.
- Breadboard-friendly.
- More explicit silkscreen.
The low-power Microchip 8-bit AVR RISC-based microcontroller featuring 32KB self-programming flash program memory, 2.5KB SRAM, 1KB EEPROM, USB 2.0 full-speed/low speed device, 12-channel 10-bit A/D-converter, and JTAG interface for on-chip-debug.
The device achieves up to 16 MIPS throughput at 16 MHz. 2.7 – 5.5 Volt operation.
magneval –
It’s a very good product, quite powerfull especially with its Sreen to show debugging info and the connectivity daugther board to use either bluetooth or WI-FI
The only drawback is that I can not manage to compile Libraries exemples codes on arduinodroid, wereas it compile ok on windows or Linux.
contact –
Excellent produit que j’ai commencé à tester hier avant de m’y mettre plus sérieusement.
Merci pour ce petit bijou.